Download file: AutoSPATZAS-01_SE_English.exe [12,8 MB]
This edition is intended for the application during the first installation of weld timers and for service purposes. The software offers the same functional range as the licensed version, but is subject to the following restrictions:
Intended purpose of the limited version:
Requirements:
If you wish to use the functions of the AutoSPATZAS-01 beyond the limitations, we recommend the purchase of a corresponding licence.
The characteristics of the software are described in detail on the product page of the AutoSPATZAS-01 software.
Installation guidelines:
After downloading, please start the installation process by double-clicking the file
AutoSPATZAS-01_SE_English.exe. The installation package will be extracted into
the desired folder. As a default, folder C:\ is used so that the files will be
extracted to C:\AutoSPATZAS-01_SE_English\, if you do not specify another folder.
After that, please double-click setup.exe. The software will guide you through the
process of installation.
The weld timer has to be connected to the PC via the serial port.
By default, COM-port 1 and the highest baud rate (115200 bit/s) are pre-configured in the software.
Changing COM-Port / baud rate:
If you have to change the COM-port and/or the baud rate, please follow these instructions:
Click
Pin assignment for the RS232 interface cable:
Shielding on connector housing on both sides
| DB9F | DB9F |
|---|---|
| 1 | 4 |
| 2 | 3 |
| 3 | 2 |
| 4 | 1 |
| 5 | 5 |
| 7 | 8 |
| 8 | 7 |
| 9 | 9 |
