SPATZ+H300 High Frequency Inverter Power Source
- Ethernet- and USB-Interface -
The SPATZ+H300 high-frequency inverter power source with its 20,000 Hz clock frequency is the all-purpose, cost-effective alternative to all of the transistor-controlled power supplies for micro welding and small component welding. With its rapid reaction speed, the SPATZ+H300 displays high-performance, lasting welding capability, functioning with just as much precision at 100 A as it does at 9,000 A.
Each welding operation is feedback controlled during the procedure. The control process takes place very quickly based on the 20 kHz inverter frequency. Actual values are compared with target values every 0.025 ms. The output power is adapted during the welding process if targets are not being met. Constant Current Control (CCC), Constant Power Control (CPC) and Constant Voltage Control (CVC) can all be used. At the end of each weld, the SPATZ+H300 checks whether the actual welding parameters keep within the set limits.
The SPATZ+H300 timer and high-frequency inverter are housed in a compact IP54-protected housing, which weighs a total of 25 kg / 55.1 lb. While the external high-frequency transformer needs to be installed close to the welding site, the SPATZ+H300 can be installed within the vicinity of the machine.
Online programming and analysis are the connecting links between production, quality control and process engineering. There are two different seperately sold software packages available.
SPATZStudio: Further detailed information is available for the maintenance via notebook and the USB-interface.
SPATZStudioNET: Integration and crosslinking of welding systems with a line PC by Ethernet with full online functionality.
The specific advantages of the SPATZ+H300 high-frequency inverter, such as its low weight and high output voltage, allow the easy system integration. The high output voltage enables relatively long welding power lines to lead to the welding position.
The SPATZ+H300 high-frequency inverter is deliverable for a mains input voltage range from 3~400 V to 500 V.
|Number of programs||1024|
|Welding impulses / program||16|
|Control modes||CCC, CPC,CVC|
|Weld parameter monitoring||yes|
|Stepper function||for CCC, CPC, CVC|
|Slope up / slope down||yes|
|Signal inputs||current, voltage, force, penetration|
|Output for proportional valve||yes|
|Mains voltage U1||3~400 V-500 V 50/60 Hz|
|Max. power Smax||60 kVA with 400 V|
|Nominal power SN||33 kVA with 50 % duty, 400 V|
|Welding current range I2||100 - 9,000 A with 6 % duty cycle|
|Welding voltage U2N||10 V DC|
|Cooling water||4 l/min at 20 °C
1.1 gal(US)/min at 68 °F
|Type of protection||IP54|
|Dimensions (H x W x D)||380 x 430 x 210 mm
15.0 x 16.9 x 8.3 in
|Weight||25 kg / 55.1 lb|
|Colour||light grey / RAL7035|
|Included in delivery:||documentation|