SPATZH300 High Frequency Inverter Power Source
This device is no longer manufactured. The information contained on this page is therefore not current.
Visit SPATZ+H300 instead.
The SPATZH300 high-frequency inverter power source with its 20,000 Hz clock frequency is the all-purpose, cost-effective alternative to all of the transistor-controlled power supplies for micro welding and small component welding. With its rapid reaction speed, the SPATZH300 displays high-performance, lasting welding capability, functioning with just as much precision at 100 A as it does at 9,000 A.
Each welding operation is feedback controlled during the procedure. The control process takes place very quickly based on the 20 kHz inverter frequency. Actual values are compared with target values every 0.025 ms. The output power is adapted during the welding process if targets are not being met. Constant Current Control (CCC), Constant Power Control (CPC) and Constant Voltage Control (CVC) can all be used. At the end of each weld, the SPATZH300 checks if the actual welding parameters are keeping within the limits set.
The SPATZH300's timer and high-frequency inverter are housed in a compact IP54-protected housing, which weighs a total of 27,5 kg / 60.6 lb. While the external high-frequency transformer needs to be installed close to the welding site, the SPATZH300 can be installed within the vicinity of the machine.
The SPATZBG-02 operating device is used for operating the functions and adjusting the welding parameter settings. The curve characteristics of the process signals and the measured values of the last 10,000 welds can be read by the SPATZBG-02 at any time.
The specific advantages of the SPATZH300 high-frequency inverter, such as its low weight and high output voltage, allow the easy system integration. The high output voltage enables relatively long welding power lines to lead to the welding position.
The SPATZH300 high-frequency inverter is deliverable for a mains input voltage range from 3~400 V to 500 V.
|Number of programs||63|
|Welding impulses / program||16|
|Control modes||CCC, CPC,CVC|
|Weld parameter monitoring||yes|
|Stepper function||for CCC, CPC, CVC|
|Slope up / slope down||yes|
|Signal inputs||current, voltage, force, penetration|
|Output for proportional valve||yes|
|Mains voltage U1||3~400 V-500 V 50/60 Hz|
|Max. power Smax||60 kVA with 400 V|
|Nominal power SN||33 kVA with 50 % duty, 400 V|
|Welding current range I2||100 - 9,000 A with 6 % duty cycle|
|Welding voltage U2N||10 V DC|
|Interfaces||BG-02, RS-232, MASDAT|
|Cooling water||4 l/min at 20 °C
1.1 gal(US)/min at 68 °F
|Type of protection||IP54|
|Dimensions (H x W x D)||380 x 380 x 210 mm
15.0 x 15.0 x 8.3 in
|Weight||27.5 kg / 60.6 lb|
|Colour||light grey / RAL7035|
|Included in delivery:||-documentation
-SPATZBG-02 connecting cable 3m / 118.1 in
-SPATZBG-02 connecting cable holder