Deutsch    |   Français 

  Products     Applications     Partners     News     Download     About Us     Contact  

SPATZH6000 High Frequency Inverter Power Source


Attention:

This device is no longer manufactured. The information contained on this page is therefore not current.

Visit SPATZ+H9000 instead.

The SPATZH6000 high-frequency inverter power source, with its 20,000 Hz clock frequency, is the all-purpose, cost-effective alternative to all of the transistor-controlled power supplies for micro welding and small component welding. With its rapid reaction speed, the SPATZH6000 displays high-performance, lasting welding capability, functioning with just as much precision at 100 A as it does at 9,000 A.

Each welding operation is feedback controlled during the procedure. The control process takes place very quickly based on the 20 kHz inverter frequency. Actual values are compared with target values every 0.025 ms. The output power is adapted during the welding process if targets are not being met. Constant Current Control (CCC), Constant Power Control (CPC) and Constant Voltage Control (CVC) can all be used. At the end of each weld, the SPATZH6000 checks if the actual welding parameters are keeping within the limits set.

The SPATZH6000's timer, power unit and special high-frequency transformer are housed in a compact IP54-protected housing, which weighs a total of 28 kg / 61.7 lb. The SPATZBG-02 operating device is used for operating the functions and adjusting the welding parameter settings. The curve characteristics of the process signals and the measured values of the last 10,000 welds can be read by the SPATZBG-02 at any time.

The specific advantages of the SPATZH6000 high-frequency inverter, such as its low weight and high output voltage, allow the easy system integration. The high output voltage enables relatively long welding power lines to lead to the welding position.

The SPATZH6000 high-frequency inverter is deliverable for 3~400 V-500 V mains input voltage.

Technical Data  
Type SPATZH6000
Number of programs 63
Welding impulses / program 16
Control modes CCC, CPC,CVC
Weld parameter monitoring yes
Stepper function for CCC, CPC, CVC
Force schedule yes
Slope up / slope down yes
Signal inputs current, voltage, force, penetration
Output for proportional valve yes
Mains voltage U1 3~400 V-500 V 50/60 Hz
Max. power Smax 60 kVA with 400 V
Nominal power SN 33 kVA with 50 % duty, 400 V
Welding current range I2 100 - 9,000 A with 6 % duty cycle
Welding voltage U2N 10 V DC
Interfaces BG-02, RS-232, MASDAT
Digital inputs 13
Digital outputs 8
Cooling water 4 l/min at 20 °C
1.1 gal(US)/min at 68 °F
Type of protection IP54
Dimensions (H x W x D) 380 x 380 x 210 mm
15.0 x 15.0 x 8.3 in
Weight 28 kg / 61.7 lb
Colour light grey / RAL7035
Included in delivery: -documentation
-SPATZBG-02 connecting cable 3m / 118.1 in
-SPATZBG-02 connecting cable holder